Replacing Floor Joists With Concrete Slab

Then use pry bars and your reciprocating saw to pry and cut the floor joist away from the subfloor.

Replacing floor joists with concrete slab.

These will be the end sill plates that support the ends of the floor joists. A few points ground floor slabs are only suitable for load bearing ground not suitable for shrinkable clay soils and or nearby trees lay hardcore blinding dpm concrete insulation pipes screed ditra mat tiles. Pry the floor joist from the subfloor with the back of your hammer. Replace a timber floor with a concrete slab just put the joists back on the jarrah sill looks pretty dry and solid.

Secure each length to the slab with concrete nails spaced approximately 80 cm 32 inches apart and 20 to 30 cm 8 to 12 inches from each end. Start by cutting out a small 1 2 in 2 5 5 1 cm section of the floor joist with a reciprocating saw. Do it piecemeal room by room. A few dynabolts would be ok but it is not going anywhere.

Begin with dry wedge in shim on block s between every other joist. This will create a weak spot. Iggy apr 2 16 at 8 31. If your ground floor timber floors have become infested with insect damage or dry rot you might choose to replace them with concrete floors.

Install it flat on the slab surface with the outside edge aligned against the side wall or the edge of the floor line. Im sure removing a suspended floor and replacing with a slab would work fine. These will be the end sill plates that support the ends of the floor joists. Secure each length to the slab with concrete nails spaced approximately 32 inches apart and 8 to 12 inches from each end.