Removing Carpet Spikes

Begin at the top of the stairs.

Removing carpet spikes.

Fold the carpet over for easy cutting and slice it into narrow strips. For concrete subfloors tack strip or the actual nail removal can be frustrating. Carpet can stain and wear out over time so plan to replace it every five to ten years especially if it is installed in high traffic areas like living rooms. Remove the baseboards and pull up a corner of the carpet using a claw puller or pliers.

Pry up the metal nosing and remove it if present. You may also need to remove your carpet if you have hardwood floors underneath that you would like to refinish. Removing these strips that once held your carpet is the most tedious part of carpet removal. During removal small divots in the concrete will appear and should not be a concern.

Then grab the carpet by hand and continue to pull it up along an entire wall. Its not that hard with these tips from clay king from aaa flood drying with 28. To detach the carpet from the tack strip that holds the carpet in place along walls start in a corner. After pulling up your carpet you will most likely have tack strips left around the perimeter of the room.

If you re aggressive enough one or two solid blows with the hammer against the heel of the pry bar should be sufficient to dislodge the nails. A very easy way to remove carpet tack strip from the basement concrete floor. If not cut the carpet near the top of the top stair riser. How to lift a carpet up without damaging it.

In most cases glue down carpet cannot be lifted up without damaging the backing or tearing the carpet. If you are pulling up carpet from stairs. Carpet is installed using glue or tack strips. You need to loosen about a foot of carpeting to attach to the machine.

In order to remove carpet easily and efficiently it s best to cut the carpet into 4 foot wide strips.